Configuring the RF Signal
R&S
®
SMBV100B
287
User Manual 1178.4460.02 ─ 03
An RF or LF frequency and RF level sweep signal, processed continuously,
step-by-step or individually and with selectable trigger modes. You can only run
one sweep at a time.
–
List mode
The RF signal is based on a list of predefined frequency and level values pairs
and step widths.
See
Chapter 6.10, "Varying the RF Signal in List or Sweep Mode"
6.1
Required Options
The equipment layout for generating the RF signal includes:
●
Base unit
●
Option frequency (R&S
SMBVB-B103/-KB106) for signal path A
6.2
How to Access the RF Settings
Access:
1. In the block diagram, select the block "RF > RF".
2. Select the required function form the list.
The RF block comprises all functions and settings concerning the RF signal. These
include the RF frequency and level settings with all enhanced functions for improv-
ing the signal characteristics, the analog modulations, list and sweep mode set-
tings as well as connector assignments and measurement functions of the RF sig-
nal.
6.3
How to Activate the RF Signal Output
Per default, the RF output signal is deactivated. The previous state is restored when
the signal is reactivated.
To activate the RF output
1. Configure the RF signal as required.
Set, for example, the frequency and level values.
2. Activate the RF output in one of the following ways:
a) Select "Level > RF ON > On"
b) Press the [RF on/off] key at the front panel.
How to Activate the RF Signal Output
