Rohde & Schwarz SMBV100A, Руководство по эксплуатации

Страница: 248 / 911

Instrument Function
R&S
®
SMBV100A
233 Operating Manual 1176.8016.02 ─ 17
Sensor" function, a table with correction values for external test assemblies can be
automatically determined, e.g. for compensating the frequency response of cables.
The User Correction list with the correction values acquired by the sensor is generated
in the "Edit User Correction List" menu. The correction values can be acquired any
time irrespective of the modulation settings of the generator.
If user correction is activated, the "UCOR" display (User Correction) is shown in the
header together with the "Level" display. The RF output level is the sum of both values.
"Level" + "UCOR" = Output level
If activated, user correction is effective in all operating modes.
5.5.9.1 User Correction Menu
To open the "User Correction" menu, select "RF/A Mod > Configure User Correction"
or use the MENU key under "RF/A Mod".
The combined menu "ALC/UCOR" is divided into the several sections.
The top sections provide access to the level and attenuator settings, see Chap-
ter 5.5.6.2, "RF Level Dialog" , on page 221, and to the automatic level control settings,
see Chapter 5.5.7, "Automatic Level Control - ALC" , on page 226.
User Correction Settings
The "User Correction" settings are set in the most lower section of the combined dia-
log; this section is used to activate/deactivate user correction, and to create, select and
activate the lists.
State - User Correction
Activates/deactivates user correction.
The "UCOR" status message appears in the frequency and level display.
Remote command:
[:SOURce<hw>]:CORRection[:STATe]
on page 730
User Correction Value - User Correction
Indicates the current value for level correction.
Remote command:
[:SOURce<hw>]:CORRection:VALue?
on page 730
User Cor. Data - User Correction
Calls the "File Select" menu for selecting and creating a list or the "File Manager".
RF Block