Rohde & Schwarz SMBV100A, Руководство пользователя

Страница: 751 / 780

Hardware Interfaces
R&S
®
SMBV100A
734 Operating Manual 1407.6062.32 ─ 08
A Hardware Interfaces
This section covers hardware related topics, like pin assignment of the GPIB bus inter-
face, monitor and AUX I/O connectors.
The remote control interfaces are described in detailes in
​
chapter 6, "Remote Control
Basics" , on page 392.
For specifications refer to the data sheet.
A.1 GPIB Bus Interface
Pin assignment
Fig. 1-1: Pin assignment of GPIB bus interface
Bus lines
●
Data bus with 8 lines D0 to D7:
The transmission is bit-parallel and byte-serial in the ASCII/ISO code. D0 is the least
significant bit, D7 the most significant bit.
●
Control bus with five lines:
IFC (Interface Clear): active LOW resets the interfaces of the instruments connected
to the default setting.
ATN (Attention): active LOW signals the transmission of interface messages, inactive
HIGH signals the transmission of device messages.
SRQ (Service Request): active LOW enables the connected device to send a service
request to the controller.
REN (Remote Enable): active LOW permits switchover to remote control.
GPIB Bus Interface