Rohde & Schwarz SMBV100A, Руководство пользователя

Страница: 614 / 780

Remote Control Commands
R&S
®
SMBV100A
597 Operating Manual 1407.6062.32 ─ 08
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:PHASe[:STARt] <Start>
The command sets the start phase for the individual carriers in the defined carrier range.
If the command
:BB:MCCW:EDIT:CARR:PHAS:STEP
is used to define a step width, the
phase entered here applies only to the starting carrier. The phases of the remaining car-
riers are stepped up or down by the phase value specified in
the
:BB:MCCW:EDIT:CARR:PHAS:STEP
command.
The phase settings are only valid if optimization of the crest factor is disabled
(
SOURce:BB:MCCW:CFACtor:MODE OFF
).
Parameters:
<Start> float
Range:
0 to 359.99
Increment: 0.01
*RST:
0
Example: BB:MCCW:EDIT:CARR:PHAS 90 DEG
sets a start phase of 90° for the carriers in the carrier range.
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:POWer:STEP <Step>
The command sets the step width by which the starting power of the carriers in the defined
carrier range will be incremented.
Parameters:
<Step> float
Range:
-80 to 80
Increment: 0.01
*RST:
0
Example: BB:MCCW:EDIT:CARR:POW -80dB
sets a power of -80 dB for the carriers in the carrier range.
BB:MCCW:EDIT:CARR:POW:STEP 1 dB
the power phase is incremented by dB for each carrier, i.e. the
first carrier has -80 dB, the second -79 dB, etc.
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:POWer[:STARt] <Start>
The command sets the power for the individual carriers in the defined carrier range. If the
command
:BB:MCCW:EDIT:CARR:POW:STEP
is used to define a step width, the power
entered here applies only to the starting carrier. The power of the remaining carriers is
stepped up or down by the power specified in the
:BB:MCCW:EDIT:CARR:POW:STEP
command.
Parameters:
<Start> float
Range:
-80 to 0
Increment: 0.01
*RST:
0
SOURce Subsystem