Analyzer R&S
UP300/350
E-1147.2759.00
6-232
Operating Manual, 11/2007
Selecting the Measurement Result Display
Use
You can select which measurement values are to be shown in the display
area:
RMS & FREQ
RMS and frequency are displayed.
RMS & DC
RMS and DC voltage are displayed.
Selecting the
measurement result
display
1.
Press the
function key
in the
menu.
A selection field containing the available settings is displayed. The
default setting is “RMS & FREQ“.
2.
Use the
rotary knob
[11] to select a setting.
3.
Press the
ENTER key
[5] to close the selection field.
The new setting is stored and displayed in the display area.
Activating/Deactivating the Filters
Use
You can select up to 3 individual filters in the signal path. This filter is
configured in the FILTER menu (
Ê
6-282). The filter is identical for all
measurements and can be activated or deactivated separately for each
measurement function.
Note:
The setting is always valid for both channels (Ch 1&2).
Activating filters
1.
Press the
function key
in the current
measurement
menu
.
The function key is highlighted and the new setting is stored. After the
filter is switched on, the input signal is filtered.
The current status is displayed in the parameter field.
Deactivating filters
2.
Press the
function key
in the current
measurement
menu
.
The function key is
no longer highlighted
. The input signal is measured
without filter.
The current status is displayed in the parameter field.
Ch 1&2
Ch 1&2
Содержание Smart Instruments UP300
Страница 1: ...11 2007...
Страница 20: ...R S UP300 350 E 1147 2759 00 1 20 Operating Manual 11 2007...
Страница 30: ......
