Rohde & Schwarz Smart Instruments UP300, Руководство по эксплуатации

Страница: 117 / 355

R&S UP300/350 Generator
Operating Manual, 11/2007 6-117 E-1147.2759.00
Entering the Signal Amplitude
Use You can enter the amplitude of the output signal as an RMS value.
Selecting
the channel 1. Press the numeric keys 1 , 2 , or 3 to select channel Ch 1 , Ch 2 , or both
channels Ch 1&2 .
The selected channel is displayed in green in the channel display.
Entering the
signal amplitude
2. Press the function key in the menu.
An entry field containing the currently applicable setting is displayed. The
default setting is “100 mV (0.1 FS)”. At the same time, the function keys
[13] are assigned various units of measurement.
Analog Digital
3. Enter a value ( Ê 5-65) and complete the entry by selecting a unit of
measurement (function key).
The permissible entry range is:
0
≤
AMPL
≤
7.495 V (Analog)
0
≤
AMPL
≤
0.9999 FS (Digital)
The new setting is stored and displayed in the parameter field.
(Analog)
(Digital)
Note: The maximum limit of signal amplitude applies if only the
SINE generator function is set. If other generator functions (e.g. DC
OFFSET, NOISE) are activated, their amplitude will also be taken into
consideration and the maximum signal amplitude decreases accordingly.
Ch 1 Ch 2