Rohde & Schwarz Smart Instruments UP300, Руководство по эксплуатации

Страница: 108 / 355

Generator R&S UP300/350
E-1147.2759.00 6-108 Operating Manual, 11/2007
6.2.1.3.2 Entering the Sample Frequency Offset
Use Using the Rate Offset parameter, you can shift the sample frequency in
relation to the nominal value.
Note: The setting is always valid for both channels (Ch 1&2).
Entering the
rate offset
1. Press the function key in the menu.
An entry field containing the currently applicable setting is displayed. The
default setting is “0 ppm“.
2. Enter a new value ( Ê 5-65).
The permissible entry range is:
-1000 ppm
≤
RATE OFFSET
≤
1000 ppm
The new setting is stored and displayed in the parameter field.
6.2.1.3.3 Setting the Validity Bit
Use
Using the validity bit, you can set the validity identification within the AES
EBU data stream:
ƒ Valid
The validity bit has been set.
ƒ Invalid
The validity bit has not been set.
Note: The setting is always valid for both channels (Ch 1&2).
Selecting the
validity bit
1. Press the function key in the menu.
A selection field containing the available settings is displayed. The
default setting is “valid“.
2. Use the rotary knob
[11] to select a setting.
3. Press the ENTER key
[5] to close the selection field.
The new setting is stored and displayed in the parameter field.
Ch 1&2
Ch 1&2