Rohde & Schwarz R&S UPP, Руководство пользователя

Страница: 628 / 938

Instrument Functions
R&S
®
UPP
612 User Manual 1411.1055.32 ─ 10
●
If Trace A and Trace B are both activated and the file to be imported contains a
stereo trace, then both traces are imported, namely A to A and B to B.
The following applies to all the cases listed:
If the file contains more than one scan a warning is given and the first scan from the
file is taken for the Replace function.
If "Hold" is selected in the parameter fields "Reference ", "Limit Upper " and "Limit
Lower " the current settings are
not changed by the imported scan. .
5.53.2 Equalization Files
The loading of equalization files takes place in the generator; see section Chapter 5.6,
"Generator Signals" , on page 232.
Equalization files from the R&S UPL can still be used.
5.53.3 Sweep Lists
The loading of sweep lists takes place in the generator; see section on page Chap-
ter 5.6, "Generator Signals" , on page 232.
Sweep lists from the R&S UPL can still be used.
Sweep lists from the R&S UPL have different file name extensions:
●
SPF for frequency values in Hz
●
SPV for level values in V or FS
●
SPO for on-time values in s
●
SPI for interval values in s
●
DWL for dwell time values in s
From these file name extensions the R&S UPP recognizes whether the loading pro-
cedure is allowed. It is therefore recommended that the file name extensions of the old
R&S
UPL files should not be changed!
5.53.4 Limit Files
The loading of limit files takes place in the DispConfig panels in the parameter fields
"Limit Upper ", "Source " = File and "Limit Lower ", "Source " = File.
The Y values of the limit files are always interpolated onto the current x-axis, so that
the desired trace is always produced regardless of the number of interpolation points in
the limit file. Limit files from the R&S
UPL can also be used but, in contrast to limit files
from the R&S UPP , there is no plausibility check as to whether the numerical values
in the file match the current setting, since R&S UPL files do not contain the associated
units.
Load