Rohde & Schwarz R&S UPP, Руководство пользователя

Страница: 504 / 938

Instrument Functions
R&S
®
UPP
488 User Manual 1411.1055.32 ─ 10
Range from -120 dB (lowest level) up to 120 dB (highest level).
Note: Volume settings above 0 dB may cause the enlarged digital signal to be over-
driven and thus the monitoring signal to be distorted.
If "Signal Source" is set to "Track" and if CTRL+F9 is pressed on the external keypad,
the following panel appears on the screen
which can be used to change the output voltage simultaneously for both monitor out-
puts.
If a mouse is connected to the R&S UPP, the horizontal slider can be operated
directly. The output voltage can also be adjusted using [Tab ] / [Shift Tab ] in 1-dB steps
and with [page up / down ] in 10-dB steps on the external keypad.
The entry window is closed again by clicking the cross in the top right-hand corner,
using ENTER or pressing CTRL+F9 again.
Remote command:
AUXiliaries:SPEaker:VOLume<n3>
on page 778
Enable
For enabling or disabling the trigger output.
If the trigger output is deactivated, there is a low level at the TRIGGER OUT BNC jack
on the rear of the instrument.
Remote command:
AUXiliaries:TRIGger:OUTPut:ENABle
on page 778
Mode
Operating mode of the TRIGGER OUT BNC jack on the rear of the instrument.
"Cascade" Reserved for later applications.
"Gen Sync" After starting the generator, a positive pulse with a length of 1 ms is
output at the TRIGGER OUT BNC jack on the rear of the instrument;
the pulse can be used to trigger external instruments or circuits.
The delay determines the time from the start of the generator to the
output of the trigger pulse.
Auxiliaries Panel