Rohde & Schwarz R&S RTO2000 Series, Начало работы, Страница: 92 / 106

Operating the Instrument
R&S
®
RTO2000
92 Getting Started 1332.9719.02 ─ 08
5.7 Using Dialog Boxes
All functionality is provided in dialog boxes as known from computer programs. You
can control the instrument intuitively with the touchscreen. This section provides an
overview of the accessing methods and describes how to use the dialog boxes.
Each dialog box has four icons in the upper right corner:
Go back: opens the previously opened dialog box.
Go forward: opens the next dialog box.
Minimizes the dialog box to a small box that only contains the last selected function.
Closes the dialog box.
For direct access to important control and measurement functions use the toolbar, see
Chapter 5.5, "Toolbar" , on page 83.
To open a dialog box
► Perform one of the following actions:
● Tap the required menu, and then the menu entry.
● Press the function key on the front panel.
● If a results box is open, tap the
icon to open the corresponding dialog box.
● To open the "Vertical" dialog box of a waveform, tap its signal icon. For XY-
waveforms, the "XY Diagram" tab opens.
● Tap the horizontal or trigger label to open the "Horizontal" or "Trigger" dialog
box, respectively.
To minimize a dialog box
If you want to change only one setting during analysis, and you need to change it
often, you can display a small box that only contains the required setting.
1. Tap the function that you need to modify.
2. Tap the "Minimize" icon in the upper right corner of the dialog box.
The dialog box turns into a small box that contains only the "Wfm Arithmetic" set-
ting.
Using Dialog Boxes