Rohde & Schwarz R&S FSP Series, Руководство по эксплуатации

Страница: 580 / 796

R&S FSP Remote Control – Description of Commands
SENSe Subsystem
6.186 Operating Manual 1164.4556.12 - 06
[SENSe<1|2>:]MPOWer:RESult:MIN?
This command queries the minimum power value in a multiple burst power measurement as
configured and initiated with
SENSe:MPOWer[:SEQuence]
. The unit used for the return values is
always dBm.
If no measurement result is available, the command will return a query error.
Example:
*ESE 1
*SRE 32
'Configuration of status reporting systems for the generation of an SRQ on
operation complete
SENSe:MPOWer
935.2MHz,1MHz,434us,VIDEO,50PCT,5us,MEAN,20;*OPC
'Configuring and starting the measurement
...
'Further actions of the control computer during measurement
On SRQ:
'Response to service request
SENSe:MPOWer:RESult:MIN?
Characteristics: *RST value: --
SCPI: instrument-specific
Mode: A-F, A-T
[SENSe<1|2>:]MPOWer[:SEQuence] <analyzer freq>,<rbw>,<meas time>,<trigger source>,
<trigger level>,<trigger offset>,<type of meas>,<# of meas>
This command configures the instrument setup for multiple burst power measurement and starts a
measurement sequence. When synchronizing the command with *OPC, a service request is
generated as soon as the defined number of individual measurements (# of meas) is reached.
To reduce the setting time, the setup is performed simultaneously for all selected parameters.
The command in the form of a query makes the instrument settings, performs the defined number of
measurements and outputs the measurement results list.