Getting Started
R&S
®
Spectrum Rider FPH
66
User Manual 1321.1011.02 ─ 06.00
2. Select either "Repetitive" or "Once" to turn on the audio signal.
If you have selected "Once", the R&S Spectrum Rider beeps once if the battery
runs out of power. For a continuous beep, select "Repetitive".
3. Select "Off" to turn off the beeper.
3.2.7.9
Resetting the R&S Spectrum Rider
You can either preset the R&S Spectrum Rider or reset it to factory settings.
Presetting the R&S Spectrum Rider
The [PRESET] key resets the R&S Spectrum Rider to the default setup of the currently
active operating mode.
This default setup allows you to define the instrument with a new configuration based
on a defined measurement parameter without using parameters from a previous mea-
surement unintentionally still being active.
► Press the [PRESET] key.
Resetting the R&S Spectrum Rider
A "Reset to Factory Settings" resets the R&S Spectrum Rider to the factory defaults.
During a reset, the R&S Spectrum Rider restores the original configuration. It also
deletes all customized datasets (limit lines, standards, channel tables, transducer
tables etc.). Instead, it will reinstall all the datasets that have been available after deliv-
ery.
Risk of data loss
All datasets you have saved are deleted during a factory reset.
1. In the "Instrument Setup" dialog box, select the "Reset to Factory Settings" item.
2. Confirm the entry with the rotary knob.
The R&S Spectrum Rider initiates the reset procedure and shows a warning mes-
sage box.
3. A corresponding dialog box opens for selection.
Instrument Tour
