Rohde & Schwarz NRPM OTA Power Measurement Solution, Руководство пользователя

Страница: 43 / 229

Setting up a measurement
R&S
®
NRPM
43 Mannual 1425.8663.02 ─ 08
As the R&S CMQ200 is a stand-alone product of Rohde & Schwarz, this section
does not describe the box and measurement setups in detail. If you perform an
OTA measurement with the box, you find the necessary information at:
●
www.rohde-schwarz.com/product/cmq200 , providing an overview of the
R&S CMQ200 RF shielded box with the available models and the variety of
antenna holders and feedthrough options.
●
www.rohde-schwarz.com/manual/cmq200 , providing the user manual, which
describes the hardware, the options and the accessories, and how to install
and configure the antenna modules.
●
www.rohde-schwarz.com/brochure-datasheet/cmq200 , providing the product
brochure, which deals with specific characteristics, and contains the technical
specifications and ordering information.
6.3 Connecting an R&S NRPM OTA power measure-
ment
To start up an R&S NRPM OTA power measurement, it is assumed that the fol-
lowing conditions are met:
●
All required hardware is available and ready for use, see Chapter 4.5, "Hard-
ware and software requirements" , on page 20.
●
The firmware version of the sensor module has release 2.00 or later, required
for R&S
NRPM OTA power measurements with the antenna modules
R&S NRPM-A90 or R&S NRPM-A90D.
How to: see Chapter 8, "Firmware update" , on page 83.
●
The software and drivers are installed on the controller PC.
How to: see
Chapter 4.6, "Installing the software application and drivers" ,
on page 23.
●
The (DUT) is installed and ready for operation.
●
The R&S NRPM OTA power measurement components are powered off.
● Connecting the RF frontend ............................................................................ 44
● Connecting to the controller PC ...................................................................... 46
● Using the USB connection .............................................................................. 47
● Using the LAN connection ...............................................................................50
● Connecting to the network .............................................................................. 54
Connecting an R&S NRPM OTA power measurement