Rohde & Schwarz NRP T Series, Руководство пользователя

Страница: 14 / 169

Preparing for Use
R&S
®
NRPxxT(N)
14 User Manual 1177.6023.02 ─ 08
To disconnect from the DUT
1.
NOTICE! Risk of damaging the center pin of the RF connector. Always rotate only
the hex nut of the RF connector. Never rotate the power sensor itself.
Carefully loosen the union nut at the front of the RF connector of the sensor.
2. Remove the sensor.
3.5 Connecting a Cable to the Host Interface
For connecting the power sensor to a USB host, use the host interface. See Chap-
ter 4.3, "Host Interface" , on page 26.
Depending on the USB host, use one of the following cables:
●
Computer or R&S NRP
‑
Z5 sensor hub:
R&S NRP
‑
ZKU cable with a USB connector, R&S order number 1419.0658.xx
See Chapter 3.6.1, "Computer" , on page 15.
●
Base units, R&S NRX or R&S NRP2, or other supported Rohde & Schwarz instru-
ments:
R&S
NRP
‑
ZK6 cable with a push-pull type connector, R&S order number
1419.0664.xx
See
Chapter 3.6.2, "Base Unit" , on page 18.
These cables can be obtained in different lengths up to 5 meters.
To connect a cable to the host interface of the power sensor
1. Insert the screw-lock cable connector into the host interface connector of the power
sensor.
2. Tighten the union nut manually.
To disconnect the host interface of the power sensor
1. Loosen the union nut of the screw-lock cable connector.
2. Remove the cable.
3.6 Connecting to a Controlling Host
As a controlling host, you can use:
●
Computer
●
Base Unit
For operating the power sensor, you can choose from various possibilities. For details,
see
Chapter 5, "Operating Concepts" , on page 29.
Connecting to a Controlling Host