Rohde & Schwarz EX-IQ-BOX, Руководство пользователя

Страница: 319 / 418

Remote Control Commands
R&S
®
EX-IQ-BOX
304 User Manual 1409.5570.32 ─ 05
Parameters:
<Input> SFP1 | SFP2 | SMA | LOOPback | NONE
SFP1
Selects the SFP1 ( S mall F orm-factor P luggable) interface, at
which the R&S EX-IQ-BOX is connected to the DUT to receive the
signal.
SFP2
Selects the SFP1 ( S mall F orm-factor P luggable) interface, at
which the R&S EX-IQ-BOX is connected to the DUT to receive the
signal.
SMA
Select the SMA ( S ub M iniatur version A ) interface, if the R&S EX-
IQ-BOX receives the signal from the DUT on this transmission line.
LOOPback
Assigns the internal loopback, if the signal is routed back inter-
nally.
NONE
Deactivates the input, if no connection is established.
*RST:
SFP1
Example: SOUR1:EBOX:CPRI:HW:HSSS:INP SFP1
assigns SFP1 for signal input.
Manual operation: See "Input (1409.7208.02) ; Input/Output (1409.7208.04)"
on page 160
[:SOURce<hw>]:EBOX:CPRI:HW:HSSS:OUTPut:SFP1[:STATe] <State>
Determines the SFP1 ( S mall F orm-factor P luggable) interface for signal output, i.e. aligns
the transmitter type of the DUT. You can activate more than one interface for the signal
output simultaneously, e.g. set SFP1 for signal transmission to the DUT, and SMA for
signal monitoring.
Parameters:
<State> OFF | ON
*RST:
ON
Example: SOUR1:EBOX:CPRI:HW:HSSS:OUTP:SFP1 ON
activates the SFP1 interface for signal output.
Manual operation: See "Outputs" on page 160
[:SOURce<hw>]:EBOX:CPRI:HW:HSSS:OUTPut:SFP2[:STATe] <State>
Determines the SFP2 ( S mall F orm-factor P luggable) interface for signal output, i.e. aligns
the transmitter type of the DUT. You can activate more than one interface for the signal
output simultaneously, e.g. set SFP2 for signal transmission to the DUT, and SMA for
signal monitoring.
The numeric suffix to SFP distinguishes between the available SFP interfaces.
CPRI Remote Control Commands