Protocol Settings
R&S
®
EX-IQ-BOX
204
User Manual 1409.5570.32 ─ 05
7.2.12.1
SFP Diagnostics
Sections
SFP1/SFP2 Diagnostics
indicate the most important parameters of the SFP
transceiver modules.
Difference between the R&S EXBOX-B85 breakout board versions
●
1409.7208.02 covers two SFP cages.
●
1409.7208.04 has a single SFP cage.
SFP Diagnostics
Contains information on the SFP modules and their characteristics.
Note:
The CPRI breakout board (1409.7208.02) covers two SFP cages, while the variant
(1409.7208.04) has a single SFP cage.
"Vendor"
Displays the vendor name of the SFP module.
"Part Number"
Displays the vendor part number of the SFP module.
"Connector"
Displays the connector type of the plugged-in SFP module, like LC for
a typical fiber connection.
"Bit Rate"
Displays the maximum supported bitrate of SFP module.
"Wave Length" Displays the wavelength of the plugged-in Laser SFP module for optical
data transmission.
"Vcc"
Displays the measured value of the power supply at the SFP interface
in Volts.
"Tx/Rx power"
Shows the current values of the transmitted (Tx) and the received (Rx)
optical power.
"Temperature"
Displays the current operating temperature of the SFP module.
"Warnings"
Displays various warnings in the case of high or low measured values
of Vcc, Tx/Rx power and temperature.
"Alarms"
Displays several module alarms, that is if one or more of the Vcc, Tx/
Rx power or temperature values are out of the permitted value range.
Remote command:
SFP LEDs
The LEDs in sections SFP 1 and 2 indicate the states at the SFP interfaces. The LEDs
must be blue. Red LEDs indicate errors.
"Tx Disabled"
Indicates, if the interface of the breakout board and the SFP transmis-
sion line is disabled.
"Tx Fault"
Indicates when a transmission error occurs. If the SFP is disconnected,
R&S
DigIConf displays "Not Available".
CPRI
Содержание EX-IQ-BOX
Страница 147: ...Protocol Settings R S EX IQ BOX 132 User Manual 1409 5570 32 05 CPRI...
Страница 391: ......
