File and Data Management
R&S
®
AREG100A
89
User Manual 1178.7417.02 ─ 04
2. Navigate to
/var/user/
.
To display all files on a connected USB flash drive
1. Select "System Config > Save/Recall" > "File Manager".
2. Navigate to
/usb/
.
To display all files in the volatile memory
1. Select "System Config > Save/Recall" > "File Manager".
2. Navigate to
/var/volatile/
.
6.6.4
How to Map a Network Folder
Possibly you would like to transfer instrument or user settings to another
R&S
AREG100A, distribute waveform files to several instruments or you have to
access frequently the same network drive. In these cases, on a R&S
AREG100A con-
nected to a LAN you can create a shortcut to this network folder or this computer.
For information on how to set up a LAN connection, refer to:
●
Chapter 3.1.3, "Setting Up a Network (LAN) Connection"
●
Chapter 8, "Network Operation and Remote Control"
To map a network folder, proceed as follows:
1. On the computer or the network folder you want to map, enable remote access.
You can specify a list of users allowed for remote access.
The remote access settings depend on the operating system the remote computer
is using. For step-by-step instructions, refer to the documentation of the particular
operating system.
2. On the R&S
AREG100A,
enable file transfer via SMB (samba)
.
3. Select "System Config > Setup > Remote Access > Network".
Select:
a) "Address Mode > Auto (DHCP)"
b) Check that the "DNS Suffix" and "DNS Server" are correct.
4. In the "Save/Recall" dialog, select "File Manager > Map Network Share".
5. In the "Map Network Share" dialog, select:
a) In the "Network Folder" field, enter
//<IP Address>/user
or
//
<Server Name>/user
.
b) In the "Local Folder" field, enter an alias name, e.g.
setups
.
c) Enter the "User Name" and "Password" of a user with a remote access permis-
sion to the selected network folder.
d) If necessary, enable "Reconnect at Startup".
e) Select "Connect".
Using the File Manager