Factory Default Settings
R&S AM300
E-1007.9922.12
6-68
Operating manual, 02/2005
6
Working with the R&S AM300
In this chapter
Chapter 6 fully explains all the functions of the arbitrary and function
generator, and the application of these functions. The menus are described in
the same sequence as the procedure for configuring and producing an output
signal:
R&S AM300 default settings
Setting signal parameters
Selecting and configuring output signals
Further information
The operating concept is explained in chapter 5, which also contains an
overview of the menus and functions.
The index at the end of this manual will also help you find the information you
want.
6.1
Factory Default Settings
Switching on for the
first time
When the R&S AM300 ( 3-40) is switched on, the settings used when the
instrument was last switched off are restored. When you switch on for the first
time and if the "Factory" setting has been selected as the PRESET default
setting ( 6-201), the factory default settings are activated:
Parameter Setting
Channel CH1 Channel CH2
Waveform
Waveform (WAVEFORM)
Sine
Sine
Signal frequency (FREQ)
1 kHz
1 kHz
Signal amplitude (AMPL)
2 V
pp
2
V
pp
DC component (DC OFFSET)
0 V
0 V
Start phase (START PHASE)
0 deg
0 deg
Frequency coupling (FREQ CH1 = CH2)
On
Channel
coupling
Amplitude coupling (AMPT CH1 = CH2)
Off
Output coupling (OUTPUT CH1 = CH2)
Off
Phase coupling (PHASE CH1 = CH2)
Off
Duty cycle (RECT DUTY)
50 %
50 %
Function parameters
Pulse period (PULSE PERIOD)
1 ms
Pulse width (PULSE WIDTH)
200 µs
200 µs
Polarity (POLARITY)
Normal
Normal
Symmetry (SYMMETRY)
50 %
50 %
Sample frequency (SAMPLE FREQ)
100 MHz
Arbitrary mode (ARB MODE)
Normal
Signal output
Signal output (CHx ON)
Off
Off
Signal filter type (FILTER SEL)
Auto
Auto
Output filter (OUTPUT FILTER ON)
Auto
Auto
Synchronization
Sync source (SYNC SOURCE)
Comparator
Comparator
Содержание AM 300
Страница 2: ...02 2005 ...
