Preparation for Use
R&S
®
EB510
10
Getting Started 4091.7338.02 ─ 01
1.2.6
Power On and Off
The DC power connection X1 is located at the top left corner of the
R&S
EB510 rear panel. With the DC power connected, the
R&S
EB510 is in STANDBY or READY state, depending on the state
of the STANDBY toggle switch at the front panel of the R&S
EB510
when it was last switched off. The standby power is below 0.8
W.
1.2.7
STANDBY and READY
The STANDBY key is located at the bottom left corner of the front
panel. With the DC power connected, press the STANDBY key
briefly to switch the R&S
EB510 from the STANDBY to the READY
state and vice versa. In STANDBY state, the amber LED on the right
will turn on and only the power switch circuit is being powered. In this state, it is safe
to remove the DC power and disconnect the R&S
EB510 from the AC/DC power
adapter. In READY state, the green LED on the left is on. The R&S
EB510 is ready
for operation. All modules are being powered and the
R&S
EB510initiates its startup procedure.
EB510 without front control panel
In the case of EB510 without front control panel, the green Power LED dou-
bles as a 'Fail' status LED. In conditions of failure, the LED will turn red instead
of green, as shown in the figures below.
EB510 without front control panel Ready
EB510 without front control panel in Failure
mode. Refer to the Troubleshooting section in
the Operating Manual for possible actions to
take.
Setup
