Operating the R&S
SFE100 in a LAN
R&S
®
SFE100
46
Getting Started 2112.4122.62 ─ 13
To connect the R&S
SFE100 to the network
1. Fulfill all prerequisites mentioned above.
2. Make sure that the R&S
SFE100 is switched off. This is the only way to ensure that
the network connection is reliably detected and any disruptions during the opera-
tion of the R&S
SFE100 are avoided.
3. Connect the R&S
SFE100 to the network using a CAT-5 RJ-45 cable.
4. Switch on the R&S
SFE100.
To disconnect the R&S
SFE100 from the network
1. Make sure that the R&S
SFE100 is switched off.
2. Disconnect the R&S
SFE100 from the network.
9.2 Establishing a Point-to-Point Connection
To set up a single network (a LAN connection between an R&S
SFE100 and a single
computer without integration into a larger network), an IP address needs to be
assigned to the R&S
SFE100 and the computer. The IP addresses 192.168.xxx.yyy
are available for use here. xxx and yyy can assume values of 1 to 254, and the value
for the subnet mask is 255.255.255.0.
► Connect the R&S
SFE100 and the computer with a standard RJ-45 cross-over
cable.
9.3 Zero Configuration Networking
This service is available in firmware version V02.60 and later.
The R&S
mDNS Service is installed with the firmware. Using this service, you can con-
nect to a network automatically. You do not need to set up services, such as dynamic
host configuration protocol (DHCP) and domain name system (DNS), or configure the
network settings manually (see
Chapter 9.4, "Configuring the Network Card"
Zero Configuration Networking
