Setting Up the R&S
SFE100
R&S
®
SFE100
15
Getting Started 2112.4122.62 ─ 13
4.1.3 Checking the Accessories
The R&S
SFE100 comes with the following accessories:
●
Power cable
●
Getting started manual
4.1.4 Warranty Conditions
For information on warranty conditions for the R&S
SFE100 refer to the terms of the
delivery documents.
4.2 Putting Up the R&S
SFE100
The R&S
SFE100 is designed for interior use only. The R&S
SFE100 can be used in
standalone operation or can be installed in a rack.
Risk of material damage
Make sure that the following conditions are met at the operation site:
●
The ambient temperature does not exceed the range specified in the data sheet.
●
All fan openings are unobstructed and the airflow perforations are unimpeded. The
minimum distance from the wall is at least 10
cm.
Failure to meet these conditions may cause damage to the R&S
SFE100 or other devi-
ces in the test setup.
If necessary, use proper protective equipment to protect DUTs against electrostatic
discharge in the event of human contact.
4.2.1 Placing the R&S
SFE100 on a Bench Top
The R&S
SFE100 is designed for use under general laboratory conditions.
Risk of injuries
If the R&S
SFE100 is not set up securely, you or others can be injured.
Place the R&S
SFE100 on a stable and level surface. Do not place anything on top of
the R&S
SFE100, if the R&S
SFE100 is not in a level position.
Before folding out the feet at the R&S
SFE100 bottom, read the safety instructions for
instruments with fold-out feet at the beginning of this manual carefully.
Putting Up the R&S
SFE100