Operating the R&S
QAR
R&S
®
QAR
80
User Manual 1178.7200.02 ─ 09
Figure 5-24: Verification setup (side view)
●
The verification object has an offset of 14.5
cm to the right of the center of the
R&S
QAR.
Figure 5-25: Verification setup (view from above)
Verifying the system
The verification is a series of three consecutive measurements with the verification
objects. The verification objects are labeled A to C.
1. Let the R&S
QAR warm up for at least 90 minutes.
2.
NOTICE!
Handling the verification objects.
● Store the verification objects in the bag they were delivered in.
● Keep the verification objects clean and free from fingerprints.
● Do not scratch the verification objects.
● Clean the objects with a lint-free duster or a damp rag. Do not use chemicals.
Insert one of the verification objects into the mounting frame.
3. Select the corresponding DUT configuration from the "Car Type" dropdown menu.
Radar Positioning Measurements