Rohde & Schwarz 1332.4500.22, Руководство пользователя

Страница: 825 / 1476

Command Reference
R&S
®
ZNA
825 User Manual 1178.6462.02 ─ 12
CALCulate<Chn>:LIMit:LOWer:SHIFt <LimShift>
CALCulate<Chn>:LIMit:UPPer:SHIFt <LimShift>
These commands shift all lower and upper limit line segments assigned to the active
trace in vertical direction. Both commands shift
all limit lines; they have the same func-
tionality. See also Chapter 5.4.1.1, "Rules for Limit Line Definition" , on page 120.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Setting parameters:
<LimShift> Response offset value for all limit line segments.
Range:
Virtually no restriction for limit segments
Default unit: NN
Example: See
CALCulate<Chn>:LIMit:LOWer:FEED
Usage: Setting only
Manual operation: See "Shift Lines" on page 362
CALCulate<Chn>:LIMit:SEGMent<Seg>:AMPLitude:STARt <Response>
CALCulate<Chn>:LIMit:SEGMent<Seg>:AMPLitude:STOP <Response>
These commands change the start or the stop response values (i.e. the response val-
ues assigned to the start or stop stimulus values) of a limit line segment. A segment
must be created first to enable the commands (e.g
CALCulate<Chn>:LIMit:DATA
).
See also Chapter 5.4.1.1, "Rules for Limit Line Definition" , on page 120.
Tip: To define the response values of several limit line segments with a single com-
mand, use
CALCulate<Chn>:LIMit:LOWer[:DATA]
or
CALCulate<Chn>:
LIMit:UPPer[:DATA]
.
Suffix:
<Chn>
.
Channel number used to identify the active trace
<Seg> Segment number
Parameters:
<Response> Response value
Range:
Virtually no restriction for limit segments
*RST: The default response values of a segment that is
created by defining its stimulus values only (e.g. by
means of CALCulate<Ch>:LIMit:CONTrol[:DATA]),
are -40 dB.
Default unit: NN
SCPI Command Reference