Rohde & Schwarz 1332.4500.22, Руководство пользователя

Страница: 27 / 1476

Getting Started
R&S
®
ZNA
27 User Manual 1178.6462.02 ─ 12
Index Label Description
9 External Handler IO Used to connect an external Handler I/O (option R&S ZNBT-Z14), providing a Centronics
36 input/output connector.
Not yet supported.
10 External Data Logger Digital interface for data streaming.
Requires "Data Streaming Memory" option R&S ZNA-B7 (not yet available).
11 (Reference) In/Out SMA connector for external reference clock input or output.
●
Input: 100 MHz or 1 GHz
●
Output: 100 MHz
12 (Reference) In /
(Reference) Out
BNC connectors for external reference clock input and output.
●
Input: 50 kHz to 100 MHz
●
Output: 10 MHz
13 Trigger In A BNC connector for an incoming external trigger signal (LV-TTL 3.3 V, 5 V tolerant).
The optional trigger board R&S ZNA-B91 provides three additional trigger inputs (and four
trigger outputs).
14 User Port 25-pin D-Sub connector used as an input and output for other control signals (LV-TTL
3.3
V, 5 V tolerant).
See Chapter 11.3.1.1, "User Port" , on page 1418.
15 (Ground connector) The ground connector provides the ground of the analyzer's supply voltage. Use this con-
nector for ESD protection; see
"Instrument damage caused by electrostatic discharge"
on page 11.
Table 4-3: Optional rear panel elements
Index Label Description
16 Converter LO Hardware option R&S ZNA-B8 provides a local oscillator output that is particularly useful
for driving mmWave converters.
See Chapter 5.7.16, "LO Out" , on page 224.
17 Trigger In / Trigger Out BNC connectors for incoming/outgoing trigger signals (LV-TTL 3.3 V, 5 V tolerant).
Trigger inputs B to D and trigger outputs A to D are provided by the optional trigger board
R&S
ZNA-B91.
18 PuMo In/Out BNC connectors for incoming/outgoing external pulse modulator control signals (LV-TTL
3.3
V, 5 V tolerant).
Requires the optional trigger board R&S ZNA-B91.
19 BNC connectors for other incoming/outgoing control signals (LV-TTL 3.3 V, 5 V tolerant).
●
Ready for Trigger (outgoing)
●
Busy (outgoing)
●
+28 V Noise Source Control (outgoing)
●
RF Off Control (incoming)
Requires the optional trigger board R&S ZNA-B91.
22 Direct IF Access Input / Out-
put Option R&S ZNA-B26 provides direct access to the IF signal paths.
Instrument Tour