Command Reference
R&S
®
ZNA
1345
User Manual 1178.6462.02 ─ 12
Setting parameters:
<SweepType>
FLIN | FLOG | FSEG | FSINgle | TLIN | TLOG | PLIN | PLOG |
PSINgle
Keywords for the units of the stimulus values. The selected unit
must be compatible with the sweep type (
); otherwise the limit line can not be displayed
and no limit check is possible.
The parameters form three groups: FLIN, FLOG, FSEG, and
FSINgle select frequency units for the limit line. TLIN and TLOG
select time units, PLIN, PLOG and PSINgle select power units.
*RST:
FLIN
Default unit: Hz (for FLIN, FLOG, FSEG, FSINGle); s (for TLIN,
TLOG), dBm (for PLIN, PLOG, PSINgle).
Example:
SWE:TYPE POW
Select a power sweep.
CALC:LIM:CONT:DOM PLIN
Delete all existing limit line segments and select level units for
the limit line of the active trace.
CALC:LIM:CONT -20, -10
Define a limit line segment in the stimulus range between -20
dBm and -10 dBm.
Usage:
Setting only
CALCulate<Chn>:LIMit:RDOMain:COMPlex
<UnitRef>
Deletes the existing limit line and (re-)defines the physical units of the response values
of the limit line. The units of the stimulus values are defined via
.
Tip:
This command is complemented by
CALCulate<Chn>:LIMit:RDOMain:SPACing
Suffix:
<Chn>
.
Channel number used to identify the active trace.
Setting parameters:
<UnitRef>
S | SINV | Y | Z | YREL | ZREL
Keyword for the physical unit of the response values. The
parameters form four groups: S and SINV select relative units
(dB) for the limit line. Y selects admittance units (S/Siemens). Z
selects impedance units (Ω). YREL and ZREL select dimension-
less numbers (U).
Usage:
Setting only
R&S ZVR/ZVABT Compatible Commands
