Command Reference
R&S
®
ZNA
1034
User Manual 1178.6462.02 ─ 12
Setting parameters:
<Channel>
Channel number
<SweepSegFile>
String parameter to specify the name and directory of the cre-
ated sweep segment file. The default extension (manual control)
for sweep segment files is
*.SegList
, although other exten-
sions are allowed.
If no path is specified the analyzer searches the current direc-
tory, to be queried with
Example:
See
Usage:
Setting only
Manual operation:
See
MMEMory:STORe:STATe
<Compatibility>, <RecallSetFile>
Stores the configuration data of the current recall set to the specified recall set file.
MMEMory:STORe:STATe
also renames the current recall set. See example for
MMEMory:LOAD:STATe
.
Setting parameters:
<Compatibility>
1 (this value is used for compatibility with the SCPI standard but
ignored).
<RecallSetFile>
String parameter to specify the absolute or relative path of the
created recall set file. Relative paths are evaluated relative to
the current directory (see
The default extension for recall set files is
znxml
. Unless you
specify
znx
as file name extension, recall sets are always stored
in
znxml
file format.
Example:
See
Usage:
Setting only
Manual operation:
See
MMEMory:STORe:TRACe
<TraceName>, <TraceFile>[, <FormatInd>, <Format>,
<DecSeparator>, <FieldSeparator>]
Stores the trace data of a specified data trace to a trace file. Traces are created using
the
CALCulate<Ch>:PARameter:SDEFine
command.
Tip:
*.s<n>p
Touchstone files (<n> = 1, 2, 3, ...) are intended for a complete set of
<n>-port S-parameters. Data export fails if the active channel does not contain the full
set of <n>
2
traces or if the involved ports are not numbered consecutively, starting with
port 1. If the necessary traces are available,
'<trc_name>'
can be the name of any
of the traces. To create Touchstone files while less than <n>
2
single-ended traces are
available, use
.
SCPI Command Reference
