Instrument Tour
R&S
®
FSW
53
Getting Started 1338.4102.02 ─ 08
The output connector provides I/Q data streams with a sample rate of up to
600
MHz, if the R&S
FSW-B517 option is installed and active.
Output is activated in the software ([INPUT/OUTPUT] key).
See the R&S
FSW I/Q Analyzer and I/Q Input User Manual for details.
5.2.8
GPIB Interface
The GPIB interface is in compliance with IEEE488 and SCPI. A computer for
remote control can be connected via this interface. To set up the connection, a
shielded cable is recommended.
For more details, refer to "Setting Up Remote Control" in the R&S
FSW user
manual.
5.2.9
Aux. Port
A 9-pole SUB-D male connector used to provide low-voltage TTL
control signals (max. 5
V). The output signals can be used to con-
trol external devices.
5.2.10
SYNC TRIGGER OUTPUT/INPUT
Use the SYNC TRIGGER OUTPUT/INPUT connectors to synchronize several
devices (e.g. two R&S
FSWs) to a common trigger signal or reference frequency.
The R&S
FSW can output a 100
MHz signal as a trigger or reference signal to
another device. The R&S
FSW can also receive an external trigger or reference
signal at the input connector.
Rear Panel View
