Rohde & Schwarz 1065.6000.20, Руководство по эксплуатации

Страница: 238 / 438

FSE SENSe Subsystem
1065.6016.12 6.181 E-16
SENSe:DETector Subsystem
The SENSe:DETector subsystem controls the recording of measurement values via the type of detector
selected for each trace.
The suffix in SENSe<1|2> is not significant in this subsystem.
COMMAND PARAMETERS UNIT COMMENT
[SENSe<1|2>]
:DETector<1to4>
[:FUNCtion]
:AUTO
APEak | NEGative| POSitive | SAMPle| RMS
| AVERage
<Boolean>
--
:[SENSe<1|2>:]DETector<1 to 4>[:FUNCtion] APEak | NEGative | POSitive | SAMPle | RMS |
AVERage
This command switches the detector for recording of the measured value.
Example:
":DET POS"
Features: *RST value: APEak
SCPI: conforming
Mode: A
The value "APEak" (AutoPeak) displays both the positive peak value and the negative peak value
when noise is present. The positive peak value is displayed when one signal is present. The trace is
selected by means of the numeric suffix after DETector.
:[SENSe<1|2>:]DETector<1 to 4>[:FUNCtion]:AUTO ON | OFF
This command either couples the detector to the current trace setting or turns coupling off.
Example:
":DET:AUTO OFF"
Features: *RST value: ON
SCPI: conforming
Mode: A
The trace is defined by the numeric suffix at DETector.