Rockwell ArmorStratix 5700 series, Инструкция по эксплуатации

Страница: 168 / 548

168 Rockwell Automation Publication 1783-UM007F-EN-P - September 2016
Chapter 6 Install Stratix 8000 and 8300 Switches
Mount the Switch on a Wall or Panel
To mount the switch on a wall or a panel, you need M5 or #10-24 or #10-32
bolts or screws with 1.27 cm (0.5 in.) O.D. flat washers. This hardware is not
provided with the switch.
Follow these steps to mount the switch to a wall or a panel.
1. If the DIN rail latches are pushed out, push them in so they are fully
locked in place.
2. Rotate all feet to their recessed positions so that the switch can mount
flat on the wall or pane.
If greater air circulation around the switch is required, rotate the feet to
their extended positions before mounting the switch on the wall.
3. Position the rear panel of the switch against the wall or a panel in the
desired location, as shown in this figure.
4. Place M5 or #10-24 or #10-32 bolts or screws with 1.27 cm (0.5 in.)
O.D. flat washers through each DIN rail latch, and screw them into the
wall.
31777-M
1
3
4
1
2
t s
yl at a
C o c
si C
C
D V 4 2( A r
w P
) C D V
8 4 ro
nt R A
4
2( B r w P
ro
C D V
8 4 D V )C
nt R B
p x E
p ut e S
ss er
ts y
S
m e
m ra lA
te S pu
A r w P
B r w P
oj a M
lA
r
m ra
M on i
lA r m ra
ti n u
s i h T
i m t h g
a h e v e r o m th n
a e n o
w o p r e r o c
. d o T re
t e c
u d
e h ris o k f
c e l e tri s
c c o h d k
c s i e n n o t c
o w t e h t
w o p r e r o c
s
d
f e b e r o
i v r
e s
.t i n u g n i c
G
N I N R
A W
!