Rockwell Automation MagneMotion 700-0871-00, Руководство пользователя

Страница: 72 / 148

Specifications and Site Requirements
Electrical Specifications
72 MagneMotion
Rockwell Automation Publication MMI-UM013B-EN-P - April 2020
NC-12 Node Controller
The NC-12 node controller is available in two different configurations. The 700-1482-00 ver-
sion provides a standard RJ45 network connection and a 2 mm coax power connection. The
700-1573-00 version provides an M12 Eurofast network connection and an M12 Eurofast
power connection.
22–30V DC, 20 W max based on configuration and operating mode. See NC-12 Node Con-
troller on page 58 or NC-12 Node Controller, M12 Ethernet on page 59 for the mechanical
drawing.
AC Power Option
The optional remote power supply for the NC-12 node controller requires 90–264V AC @
47–63 Hz, single-phase (phase-to-phase or phase-to-neutral), 0.7 A at 100V AC (25 W max).
Inrush current 45 A/240V AC max The actual power being drawn depends on the operations
being performed. However, all power wiring must be designed to carry the full load. See the
data sheet provided by the power supply manufacturer for mechanical information.
AC Power Cable
The optional remote power supply for the NC-12 node controller is supplied with a power
cable. Contact MagneMotion for replacement cables. The AC power cable plugs directly into
the power supply.
DC Power Option
DC power from a user-supplied power supply requires 22–30V DC, 20 W.
The actual power being drawn depends on the operations being performed. Make sure that all
power wiring can carry the full load and has a limited power source or the power source is
fused to the maximum rating of the wiring.
CAUTION
High-Voltage Hazard
90–264V AC, 25 W
AC power must be disconnected before servicing.
NOTICE
Any user-supplied power supply must be NRTL/ATL approved.