Rockwell Automation Publication GMSI10-SB001A-EN-P - May 2013
Enwatch 24V DC Replacement Kit
7
Remove the Power Supply Mounting Base Plate
Use these instructions and figure to remove the power supply mounting base
plate.
Figure 5 - Wire and Screw Locations
1.
Follow the steps in the
section to safely
remove the board.
2.
If sensor grounding wires are connected to the grounding terminal strip,
disconnect them.
3.
Remove the four mounting base-plate screws and washers (circled).
4.
Lift the mounting base plate out of the Enwatch enclosure.
ATTENTION:
•
Ensure that all power to the Enwatch system has been disconnected by following
proper local safety and lockout procedures.
•
Only properly trained and certified professionals should complete these steps.
•
If your system does not resemble the one described in these instructions
immediately contact Rockwell Automation Technical Support.
Grounding Terminal Strip
