Rockwell Automation Publication 2090-IN044B-EN-P - September 2019
3
Shaft Seal Kits for Kinetix TLP Servo Motors
Remove the Shaft Seal
Follow these steps to remove the shaft seal.
1.
Remove power to the motor before removing the shaft seal.
2.
Remove the shaft key (if present) from the motor shaft.
3.
Remove old seal.
Place the insulated screw driver on the inside diameter of the shaft seal outer lip as
shown. Carefully lift the seal, work your way around the seal lift a little at a time. When
you can grasp the seal, slightly rotate it while pulling it out of the front-end bell.
4.
Inspect and clean the shaft and seal surfaces as necessary.
Use an abrasive cloth to remove any nicks or burrs from the motor shaft.
ATTENTION:
To avoid injury or damage to the equipment, remove power from the motor before
removing the shaft seal.
ATTENTION:
Avoid damage to the motor.
Do not pry against front-end bell or shaft.
ATTENTION:
Do not hammer the shaft or body of the motor when changing the shaft seal.
Do not remove screws.
Do not pry against
front-end bell or shaft.
Outer Lip
