Rockwell Automation Allen-Bradley LDAT-S03 Series, Руководство пользователя

Страница: 60 / 76

60 Rockwell Automation Publication LDAT-UM001A-EN-P - April 2016
Chapter 5 Maintenance
1.
Remove the M3 x 0.5 x 6 mm flat-head cap screws and the stator cover.
2.
Remove the M3 x 0.5 x 6 mm button-head cap screws and the end
clamps.
3.
Carefully slide the slider cover from the assembly.
4.
If you are removing the strip cover to lubricate the linear thruster, you
are finished.
5.
If you are replacing the strip cover, do the following.
Peel off the low-friction tape from the stator body and the stator cove
and discard.
Remove Encoder
1.
Remove the Allen-Bradley decal from the encoder bracket.
2.
Remove the six screws that secure the encoder bracket to the stator body
by using a Torx T10 driver.
3.
Remove the encoder bracket assembly.
4.
This exposes the encoder connector.
5.
Disconnect the encoder.
6.
Remove the encoder from encoder bracket.
ATTENTION: The slider cover has sharp edges. Use care when
handling.
EXAMPLE Use only the proper size and type of driver to remove the encoder
bracket screws or you can damage the screw heads