Kinetix 350 Single-axis EtherNet/IP Servo Drives
15
Rockwell Automation Publication 2097-IN008F-EN-P - September 2015
The drive supports some motors that do not contain temperature sensors or thermistors;
therefore, motor overload protection against excessive consecutive motor overloads followed by
power-up is not supported.
This servo drive meets the following UL 508C requirements for solid-state overload protection.
See your servo drive user manual for the interconnect diagram that illustrates the wiring between
your motor and drive.
Circuit Breaker/Fuse Selection
The Kinetix 350 drives use internal solid-state motor short-circuit protection. When protected
by suitable branch circuit protection, the drives are rated for use on a circuit that can deliver up
to 100,000 A.
See Kinetix 350 Drive Power Specifications in Kinetix Servo Drives Specifications Technical
Data, publication
for input current and inrush current specifications for your
Kinetix 350 drive.
Circuit Breaker/Fuse Specifications
on
for recommended circuit
breakers and fuses.
Motor Overload Protection Trip Point
Value
Ultimately
100% overload
Within 8 minutes
200% overload
Within 20 seconds
600% overload
ATTENTION:
Avoid overheat damage to your motor from excessive and successive motor
overload faults by following the motor and drive-combination wiring diagram that is
provided in the user manual.
