Rockwell Automation Allen-Bradley Guardmaster 442G-MABE1, Руководство пользователя

Страница: 26 / 60

26 Rockwell Automation Publication 442G-UM002A-EN-P - December 2016
Chapter 3 Use the Multifunctional Access Box in an Integrated Safety Controller-based System
10. Click Disable BOOTP/DHCP.
The module now uses the assigned configuration and will no longer issue
DHCP requests.
Restoring the Module to

DHCP Mode
When the IP Address of the Module Is Known
Use a BootP/DHCP utility to Enable DHCP.
1. Start the BootP/DHCP Software.
2. Under relation list, add a new entry for the module. Enter the MAC ID of
the module and the known IP address.
3. Select Enable DHCP.
4. A message will appear in the lower left corner indicating that the command
was successful.
IMPORTANT If you do not select Disable BOOTP/DHCP, then on a power cycle the module
clears the current IP configuration and begins sending DHCP requests again.