16
Rockwell Automation Publication CC-QS027D-EN-P - August 2015
Chapter 1
900-TC Temperature Controller Setup
Set the Parameters Used in This Building Block Application
Follow these steps to manually change parameters for this application.
1. Press and hold the
key for at least three seconds to move from the Operation function group display to the Initial
Setting function group display.
2. Change the
by using the
and
keys to set the input type to 7 or to match your input type.
3. Press the
key to move to the
setting.
4. Press
to change from °C to °F.
5. Press the
key to move to the
setting.
6. Press the
key to change from
to
.
7. Press the
key to move to the
setting.
8. Press the
key to change from
to
operation.
9. Press the
key to move to the
setting.
10. Press the
key to change the setting to or to the value you require for your application.
11. Press the
key to move to the
setting.
12. Press the
key to change the setting to or to the value you require for your application.
13. Press and hold the
key for one second to return to the Operation function group display.
14. Press the
key to move to the
setting.
15. Press the
key to change the level to
or the value you require for your application.
16. Press the
key to move to the
setting.
17. Press the
key to change the level to
or the value you require for your application.
Parameter
Description
Default Settings
Settings for This Application
Set point
0
80
Input type
5
7 (J-type thermocouple)
Temperature unit
°C (Celsius)
°F (Fahrenheit)
PID–On/off
(On/off)
(PID)
Direct–reverse operation
(reverse)
(direct)
Alarm 1 type
2
8 (absolute value, upper limit)
Alarm 2 type
2
8 (absolute value, upper limit)
Alarm value 1
0
75
Alarm value 2
0
85
IMPORTANT
Perform step 8 only if you are using a fan.
TIP
Direct (
) is typically used for fans and reverse (
) is typically used for heaters.
Содержание Allen-Bradley 900-TC
