Rockwell Automation Publication 6200-IN001A-EN-P - October 2019
15
VersaView 5000 Thin Clients, Industrial Computers, and Accessories for Hazardous Locations
Pre-configuration
Follow these steps before you remove or install a hardware component.
1.
Shut down the VersaView 5000 device and all peripherals that are connected to it.
2.
To avoid exposure to high energy levels, disconnect all cables from power outlets.
If necessary, label each cable to expedite reassembly.
3.
Disconnect all peripheral cables from the I/O ports.
4.
If the VersaView 5000 device is table or wall mounted, loosen the mounting screws.
Remove the VersaView 5000 device from its mounting.
Post-configuration
Follow these steps after you install or replace a hardware component.
1.
If the VersaView 5000 device was wall, table, or machine mounted, reinstall it to its
mounting.
Tighten the four customer-supplied M5 pan head screws to a torque that is appropriate
for the screw quality and mounted surface material.
2.
Reinstall any peripherals and system cables that were previously removed.
3.
Reconnect all external cables and power to the VersaView 5000 device.
4.
To start the VersaView 5000 device, press the power switch.
Required Tools
The following tools are required to install or replace a component:
• The appropriate tools for wall or machine mounting
• Torx 10 key or screwdriver
ATTENTION:
Make sure to read and understand all installation and removal procedures before
you configure any hardware component.
