Rockwell Automation Allen-Bradley 2094-BC01-M01-S, Руководство пользователя

Страница: 34 / 280

34 Rockwell Automation Publication 2094-UM001D-EN-P - May 2010
Chapter 2 Planning the Kinetix 6000 Drive System Installation
Establishing Noise Zones
Observe these guidelines when the 2094-AL xx S, 2094-BL xx S, or
2094-XL75S-C x LIM module is used in the Bulletin 2094 system and mounted
left of the IAM module with the AC (EMC) line filter mounted above the LIM
module:
• The clean zone (C) is to the right and beneath the Bulletin 2094 system
(gray wireway).
•
The dirty zone (D) is to the left and above the Bulletin 2094 system, and
above and below the LIM module (black wireway).
• The very dirty zone (VD) is from the filter output to IAM module.
Shielded cable is required on the EMC filter (load side) and the braided
shield attached to the clamp provided.
• The SERCOS fiber-optic cables are immune to electrical noise, but due to
their delicate nature, route them in the clean zone.
Figure 9 - Noise Zones (LIM mounted left of IAM module)
(1) If drive system I/O cable contains (dirty) relay wires, route cable with LIM module I/O cable in dirty wireway.
(2) When space does not permit the 150 mm (6.0 in.) segregation, use a grounded steel shield instead. For
examples, refer to the System Design for Control of Electrical Noise Reference Manual, publication
GMC-RM001 .
C
C
D
VD
D
D
D
D
D
D
VD
D
MAIN VAC
Line Interface Module
Kinetix 6000 System
Dirty Wireway
Clean Wireway
I/O
(1)
and Feedback Cables
Motor Power Cables
Very Dirty Filter/IAM Connections
Segregated (not in wireway)
Route 24V DC I/O
shielded cable. Route encoder/analog/registration
shielded cables.
Fiber-optic Cable
VAC Load
VAC Line
AC Line Filter
(required for CE)
No sensitive
(2)
equipment within
150 mm (6.0 in.).