Rockwell Automation Allen-Bradley 2094-BC01-M01-S, Руководство пользователя

Страница: 249 / 280

Rockwell Automation Publication 2094-UM001D-EN-P - May 2010 249
DC Common Bus Applications Appendix D
Set the Additional Bus
Capacitance Parameter
with DriveExplorer
Software In this section you set the Add Bus Cap parameter by using DriveExplorer
software.
The following hardware and software tools are required to provide the necessary
communication link between your personal computer and the Kinetix 6000 drive
system running DriveExplorer software.
Remove SERCOS Communication
Follow these steps to remove (break) SERCOS communication.
1. Remove three-phase and control power from the Kinetix 6000 drive
system.
2. Remove one of the SERCOS fiber-optic cables.
Fiber-optic cable connections (Tx and Rx) are located on the top of each
IAM/AM module.
3. Re-apply three-phase and control power.
TIP
You can also set the Add Bus Cap parameter by changing IDN
parameter values. Refer to Appendix E on
page 253 for more
information.
Description Cat. No. Version
DriveExplorer Software
(1) (2)
(1) Refer to DriveExplorer Getting Results Manual, publication 9306-GR001 , for instructions.
(2) Additional information regarding these communication and software tools is available at
http://www.ab.com/support/abdrives .
9306-4EXP02ENE 2.01 or later
Serial to SCANport Adapter
(2) (3)
(3) Refer to 1203-SSS (series B) FRN 3. xxx User Manual, publication 20COMM-UM001 , for instructions.
1203-SSS (Series B) 3.004 or later
RSLogix 5000 Software 9324-RLD300NE 15.0 or later
ATTENTION: To avoid personal injury or equipment damage, at least one
end of a SERCOS fiber-optic cable must be disconnected from the drive.
This makes sure that motion will not occur while changes are being made
to the Add Bus Cap parameter.