6 DeviceNet Base RTD and Thermocouple CompactBlock LDX I/O
Publication 1790-IN011C-EN-P - January 2015
Mount the Base Module
You can mount the base block to a panel or DIN rail. We recommend that you ground the
panel or DIN rail before mounting the block.
Dimensions
Mount on a Panel
For panel mounting, use these steps.
1.
Place the block against the panel where you want it mounted.
2.
Gently pull and position the expansion cover to the left.
3.
Place a center punch, nail, or similar device through the mounting holes in the
block and make two marks on the panel at the lower-left and upper-right corners
of the module.
IMPORTANT
The RTD and thermocouple base blocks do not support any expansion
blocks.
WARNING:
When used in a Class I, Division 2, hazardous location, this
equipment must be mounted in a suitable enclosure with the proper wiring
method that complies with the governing electrical codes.
Compact
Block LDX
1790-16BVOX
DC INPUTS
EXPANSION UNIT
16 INPUTS-DCPOWER
0
7
DC INPUTS
8
15
95 mm
(3.74 in.)
41 mm
(1.6 in.)
Expansion
Cable
Cover
44252
