Rockwell Automation 9VT201-007HTNNN, Руководство пользователя, Страница: 64 / 224

3-2 Programming and Parameters
Publication 9VT-UM001D-EN-P
Fil
e
Gr
ou
p
No. Parameter Name & Description
Values
Relate
d
UT
IL
IT
Y (
F
ile
E)
Dr
iv
e .
. .
198 [Load Frm Usr Set]
Loads a previously saved set of
parameter values from a selected user
set location in drive nonvolatile memory
to active drive memory.
Default:
Options:
0
0
1
2
3
“Ready”
“Ready”
“User Set 1”
“User Set 2”
“User Set 3”
199
D
iag
no
st
ic
s
216 [Dig In Status]
Status of the digital
inputs.
MO
T
O
R . . .
To
rq
. . .
059 [SV Boost Filter]
Sets the amount of filtering used to boost
voltage during Sensorless Vector
operation.
Default:
Min/Max:
Units:
500
0/32767
1
0 0 0 0 0 0 x x x x x x x x x x
10 0 1 2 3 4 5 6 7 8 9 11 12 13 14 15
1 =Input Present
0 =Input N ot Present
x = R eserved
Bit #
Digital In1 Digital In2 Digital In3 Digital In4 Digital In5 Digital In6
N ibble 1 N ibble 2 N ibble 3 N ibble 4
2…6
➊ ➌ ➋ ➏ ➎ ➍
No. Description
➊
File – Lists the major parameter file category.
➋
Group – Lists the parameter group within a file.
➌
No. – Parameter number.
=
Parameter value can not be changed until drive is stopped.
= 32 bit parameter.
= Drive Frames 2, 3, 4, 5 & 6.
➍
Parameter Name & Description – Parameter name as it appears on an LCD OIM, with a brief
description of the parameters function.
➎
Values – Defines the various operating characteristics of the parameter. Three types exist.
ENUM Default:
Options:
Lists the value assigned at the factory. “Read Only” = no default.
Displays the programming selections available.
Bit Bit #: Lists the bit place holder and definition for each bit.
Numeric Default:
Min/Max:
Units:
Lists the value assigned at the factory. “Read Only” = no default.
The range (lowest and highest setting) possible for the parameter.
Unit of measure and resolution as shown on the LCD OIM.
Important: Some parameters will have two unit values. For example, analog inputs
can be set for current or voltage with 320 [Anlg In Config].
Important: When sending values through DPI ports, simply remove the decimal
point to arrive at the correct value (i.e. to send “5.00 Hz,” use “500”).
➏
Related – Lists parameters (if any) that interact with the selected parameter. The symbol “ ”
indicates that additional parameter information is available in Appendix C.
32
2…6