Rockwell Automation 6181P, Руководство пользователя

Страница: 45 / 124

Rockwell Automation Publication 6181P-UM003A-EN-P - May 2014 45
Component Replacement Chapter 4
Post-configuration Follow these steps after installing or removing a hardware component.
1.
Make sure all components are installed according to instructions.
2.
Make sure that no tools or loose parts are left inside the computer.
3.
Reinstall any expansion boards, peripherals, and system cables that were
previously removed.
4.
Reinstall the cover according to the instructions on page 46 .
5.
Reconnect all external cables and power to the computer.
6.
Press the computer’s power switch to start the computer.
Required Tools The following tools are required for component replacement:
•
#2 cross-head screwdriver
•
Antistatic wrist strap
•
Side cutters (for cutting cable ties, if necessary)
Remove the Cover To install, replace, or upgrade internal computer components, you must first
remove the cover.
Follow these steps to remove the rear cover (a display computer is shown).
1.
Follow the steps for Pre-configuration on page 44 .
2.
Loosen the three screws that secure the rear cover (A).
3.
Open the cover (B) and detach it from the chassis (C).
4.
After installing, replacing, or upgrading internal computer components,
reinstall the cover as detailed in
Reinstall the Cover on page 46 .
B
A
A
A
C
C
C
Integrated Display
Model Shown