Rockwell Automation 440G-EMAS, Руководство пользователя, Страница: 27 / 44

Rockwell Automation Publication 440G-UM003A-EN-P - February 2020 27
Chapter
6
Commissioning
Switch On
The device initializes after it is switched on. OSSDs are switched off in the
meantime. The OSSD light-emitting diode lights up after initialization.
Thorough-check
Requirements
The protective device and its application must be thoroughly checked in the
following situations:
• Before commissioning
• After changes to the configuration or the safety function
• After changes to the mounting, the alignment, or the electrical connection
• After exceptional events, such as after a manipulation has been detected,
after modification of the machine, or after replacing components
The thorough check verifies the following:
• All relevant regulations are complied with and the protective device is
active for all operating modes of the machine.
• The documentation corresponds to the state of the machine, including the
protective device.
Qualified safety personnel or specially qualified and authorized personnel must
conduct the thorough checks and must be document results in a traceable
manner.
ATTENTION: Hazard due to lack of effectiveness of the protective device.
If non-compliant, it is possible that the dangerous state of the machine may not be
stopped or not stopped in a timely manner.
• Before commissioning the machine, have qualified safety personnel check and
release it.
• Make sure that the time for the safety requirement (closing the protective
device again) is longer than the response time.
IMPORTANT • Check whether the protective device of the machine is effective in all
operating modes in which the machine can be set.
• Verify that operating personnel have been instructed in the function of the
protective device before starting work on the machine. The machine
operator has overall responsibility for the instruction, which qualified
personnel must conduct.