Rockwell Automation 2080-L50E-24AWB, Руководство пользователя, Страница: 238 / 390

238 Rockwell Automation Publication 2080-UM002N-EN-E - November 2022
Chapter 12 Using microSD Cards
• Space in between setting characters (example, [P M]).
• Space in between IP address, subnet mask, and gateway address (for example, xxx. x
xx.xxx.xxx).
• Only one of the network parameter settings ([IPA], [SNM], or [GWA]) is assigned.
• [END] setting does not exist (even if there are no other settings in the configuration
file).
The microSD card becomes unusable until the ConfigMeFirst.txt file becomes readable or the
errors are corrected.
Deliver Project Updates to Customers Through Email
A benefit of using the project backup and restore feature is to allow you to deliver project
updates to customers through email. You can do so by following the example shown below.
Backup project to microSD card
The first step is to back up the project from the controller into the microSD card.
1. In the Connected Components Workbench software, verify that you have downloaded
the updated project to your controller.
2. Insert a microSD card into the microSD card slot.
3. Set the controller to program mode.
4. Under the Memory Card option in your controller settings, click Backup to Memory Card.
5. After the backup is completed, click OK.
The image files are stored in the default location on the microSD card <Micro800>\USERPRJ.
This location is where the controller loads from when the Load on power up setting is
configured to “Load Always” or “Load on Error”.
Alternatively, if you do not want to use Connected Components Workbench software to create
the project backup, you can also use the ConfigMeFirst.txt file.
Figure 22 - Example Configuration for Project Backup
The ConfigMeFirst.txt file also allows you to restore from the backup if you want to configure
the Load on power up setting to “Disable”.
IMPORTANT The Backup to Memory Card button is enabled when the controller
is in program mode and a microSD card is in the microSD card
slot.