Rockwell Automation 1606-XLS960F, Оригинальное руководство пользователя

Страница: 8 / 32

6
Rockwell Automation Publication 1606-RM028A-EN-P - September 2021
Input Inrush Current
The power supply unit is equipped with an active inrush current limitation
circuit, which limits the input inrush current after turn-on to a negligible low
value. The input current is smaller than the steady state input current.
DC Input
Do not operate this power supply unit with DC-input voltage. Use the
1606-XLE480FP-D unit instead. It can be necessary to run two
1606-XLE480EP-D units in parallel.
Output
Attributes
Values
Notes
AC 100V AC 120V AC 230V
Inrush current
(1)
(1) The charging current into EMI suppression capacitors is disregarded in the first microseconds after switch-on.
Max
25 A
peak
22 A
peak
16 A
peak
Over the entire temperature range; mains
interruptions >1 s
Typ
20 A
peak
17 A
peak
11 A
peak
Inrush energy Max
5 A
2
s 5 A
2
s 5 A
2
s
Figure 6 - Typical Turn-on Behavior at Nominal
Load - 25 °C (77 °F) Ambient
Temperature
Input Current 5 A/DIV
Input
Output
48V DC
230V AC
100 ms/DIV
Attributes Values Notes
Output voltage Nom DC 48V —
Adjustment range
— 48…54V DC Guaranteed
Max
56V DC
(1)
At clockwise end position of potentiometer
Factory setting
Typ 48.0V DC ±0.2%, at full load, cold unit, in Single Use mode
Typ 46.0V DC ±0.5%, at full load, cold unit, in Parallel Use mode
Typ 48.0V DC At no load, cold unit, in Parallel Use mode
Line regulation Max 10 mV 85…300V AC
Load regulation
Max 50 mV
In Single Use mode: static value, 0 A

20 A, see Figure 7 on
page 7
Typ 2000 mV
In Parallel Use mode: static value, 0 A

20 A, see Figure 8 on
page 7
Ripple and noise voltage Max 150 mVpp 20 Hz…20 MHz, 50 Ω
Output current
Nom 20 A
Continuously available at 48V, see Figure 7 on page 7 and Figure 8
on page 7
Nom 17.8 A
Continuously available at 54V, see Figure 7 on page 7 and Figure 8
on page 7
Nom 30 A
Short-term available BonusPower
(2)
, at 48V for typical 4 s, see
Figure 7 on page 7 and Figure 8 on page 7
Nom 26.7 A
Short-term available BonusPower
(2)
, at 54V for typical 4 s, see
Figure 7 on page 7 and Figure 8 on page 7
Typ 55 A
Up to 10 ms, output voltage stays above 40V, see Figure 10 on
page 7 . This peak current is available once every second. See Peak
Current Capability on page 22 .