XT-SurroundStone
INSTALL INSTRUCTIONS
© 2021 MSE Audio. Rev. 02.19.2021
Ultra-Fidelity Outdoor Speakers
Contact: MSE Audio, 855.663.5600 / 913.663.5600 / [email protected]
Please read the following instructions carefully before installing
your Rockustics® Rock speaker. If you have any questions re-
garding installation that are not answered in the following direc-
tions, please contact your local sound contractor or the Rock-
ustics®/MSE Audio® technical support team.
Basic Wiring
(
Diagram A
) Locate speaker wire on the underside of the rock.
If necessary, strip the wire ends and trim the wire to the appro-
priate length. Use the supplied silicone wire nut to connect the
positive (red) leads of the speaker and input wires. Repeat this
step with the negative (black) leads. Rockustics recommends
using 14ga or heavier Direct Burial cable for the connection be-
tween the amplifier and the speakers.
NOTE: The provided wire nuts are meant for permanent installa-
tion use only. If you are temporarily wiring the speakers, do not
use these wire nuts. In the event you have used the wire nuts,
and need to re-wire your system, do not attempt to unscrew the
nuts. Instead, clip the wires below the nut, and follow the steps
in the
Basic Wiring
section with a new pair of waterproof wire
nuts (these are available at most hardware stores).
Optimizing Speaker Placement for Best Sound
All Rockustics speakers can generate a high SPL (sound
pressure level). Be ready to rock, but be considerate of your
neighbors! Maximum acoustic performance should be an
important factor in determining speaker placement. Here is how
to achieve it:
1) Establish where the most likely or average listening
position will be.
2) The speakers should be placed at or close to the same
distance from that point.
3) The actual distance between the listening position and the
location of the speakers is not critical. However, keep in
mind that as the distance between listening area and
speaker is increased, there will be a noticeable decrease in
perceived volume.
4) Be sure to confirm amp power matches the power rating
on the speaker. Over-driving the speaker can lead to
permanent damage that is not covered under warranty.
Optimizing Aesthetics with Speaker Placement
All Rockustics products are designed with a boost in high fre-
quency response to accommodate for placement near plants
and other landscaping features. Feel free to position the product
within your landscaping, camouflaged near bushes or shrubs.
Rockustics products strive to blend into the natural aesthetic of
their surroundings.
Be sure to account for the wires which will run from the rock to
your stereo or audio source. Camouflage wires by running them
an inch below ground level when possible.
Diagram A
