Roche OMNI C, Инструкция по эксплуатации

Страница: 36 / 152

1 Introduction
1-28
Instructions for Use, Roche OMNI C, Rev. 4.0, December 2002
• Scan the barcodes located on the inner packaging of each electrode or enter the bar-
codes manually with the help of
.
TIP: Always save the inside packaging materials! Whenever the Roche OMNI C is taken
out of service and then brought back into service, the barcodes of the remaining
functional electrodes must be scanned again!
Fig. 32
• The corresponding electrode starts blinking on the screen.
Confirm with the
button.
• Close the measuring chamber and then the instrument cover.
18. Begin installation routines
•
Press:
• All solutions are aspirated and the system is calibrated; this may take longer than the
respective actions during operation.
• Installation is complete.
If an error occurs during one of the steps, a system stop is displayed, but the instrument has
been brought "into operation."
Please see chapter 7, "Trouble shooting", for instructions on clearing the system stop.
19. Quality control
• You must define the material before executing a quality control measurement.
• For instructions, please see chapter 5, "Quality control."
• Perform a quality control on all 3 levels.
• Make sure that the results agree with the target values (see chapter 5, "Quality con-
trol" ).