Robur GAHP Line AR Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 48 / 100

GAHP-AR – Installation, start-up, use and maintenance manual
44
Edition: 2014-08
•
4 hose clamps;
•
1 hose adaptor and condensate drain pipe in silicone rubber.
To assemble and fit the external exhaust air duct, for each single unit of the appliance,
proceed as follows:
You will need: the appliance positioned in its installation site.
1. position the clamp for fixing the pipe, with the relative metallic spacer, to the upper
part of the side panel of the unit, which comes supplied with a suitable hole;
2. using 1 hose clamp, fit the condensate trap to the T connector, then fit the latter to
the exhaust air pipe (
∅
3-
1
/
8
”) of the appliance and fix using a hose clamp;
3. using 1 hose clamp, fit the exhaust air pipe (length 29-
1
/
2
”) to the T connector;
4. fasten the pipe with the clamp previously fixed to the side panel of the unit;
5. position the exhaust terminal and fix it with 1 hose clamp;
6. fix the hose adaptor, condensate drain pipe and the relative silicon tube;
7. complete the operation, checking carefully that all components are correctly fixed in
place.
Figure 15 - Components of exhaust air duct kit
3.8 PROGRAMMING OF HYDRAULIC PARAMETERS
The operations described in this paragraph are necessary only if the appliance is not
connected to a Direct Digital Controller (DDC).
If the appliance is connected to a DDC, see the manual supplied with it.
This paragraph explains how to set the hydraulic parameters on the electronic
board of the appliance. Users not familiar with the basic procedures for the use of
the board should refer to Paragraph 2.2 "ON-BOARD ELECTRONICS" on page 17.
KEY
A
TERMINAL
B CLAMP FOR FIXING PIPE TO
PANEL OF UNIT
C EXHAUST AIR PIPE L= 750 mm
D HOSECLAMP
E "T" CONNECTOR
F CONDENSATE TRAP
G HOSE CONNECTOR +
CONDENSATE DRAIN TUBE
D
B
D
D
FRONT VIEW
A
C
E
D
F
G