End user section
Ed.
2014-08
19
Display and knob (encoder)
The display of the electronic board can be viewed through the glass of the viewing
aperture on the front panel of the appliance.
Upon activation, all of the LED of the display light up for approximately three seconds, and
then the name of the board, S61, appears. Subsequently (if the on/off command switch is
in the closed position and the summer/winter selector is in the correct position for the
operating mode required), the appliance begins to operate.
During correct operation the display shows, alternately, the following information
(regarding the operating mode that is currently active: cooling or heating): outlet water
temperature, inlet water temperature and the difference between the two water
temperatures.
Table 10 illustrates an example of what is visualised on the display for an appliance that
has been started up and is operating in "cooling" mode:
OPERATING MODE: COOLING
OPERATING DATA OF GAHP-AR
THE DISPLAY SHOWS
COLD INLET WATER TEMPERATURE
COLD OUTLET WATER TEMPERATURE
INLET WATER TEMPERATURE
- OUTLET WATER TEMPERATURE
Table 10 -
Example of data visualised on display: cold water temperature and differential
Table 11 illustrates an example of what is visualised on the display for an appliance that
has been started up and is operating in "heating" mode:
OPERATING MODE: HEATING
OPERATING DATA OF GAHP-AR
THE DISPLAY SHOWS
HOT OUTLET WATER TEMPERATURE
HOT INLET WATER TEMPERATURE
OUTLET WATER TEMPERATURE
- INLET WATER TEMPERATURE
Table 11 -
Example of data visualised on display: hot water temperature and differential
If there are operating problems, the display shows, sequentially, the operating codes
corresponding to the problem detected. A list of these codes with their description and the
procedure to follow to bring the appliance back to correct operation is provided in "TABLE
OF OPERATING CODES (firmware release 3.027)” on page 91.
The knob is used for moving between and inside the menus and parameters and for
setting the parameters, when possible. To operate the knob:
You will need:
the appliance installed and activated.
1.
Remove the front panel by removing the fixing screws.
2.
Remove the special key from the tube above the electrical panel.
3.
Remove the plug of the electrical panel to gain access to the knob.
4.
Operate the knob through the hole provided by means of the special key.
Содержание GAHP Line AR Series
