Robopac ROTOPLAT 108-308-508-708, Руководство по эксплуатации и обслуживанию

Страница: 88 / 121

ENG INFORMATION ABOUT THE USE
88
6.7. “WRAPPING CYCLE” PAGE
The page displays the controls to program the wrapping cycle.
At every activation, the button displays the enabled function with the reference icon.
A) Area: it displays the recipe name and number.
C) Button: it is used to select the type of pallet wrapping cycle.
Icon (C1) : it is used to select the “single wrapping” cycle.
Icon (C2) : it is used to select the “double wrapping” cycle.
Icon (C3) : it is used to select the “double wrapping cycle with feeder”.
D) Button: it is used to select the stop modes (automatic or programmed) of spool carriage during
upstroke.
Icon (D1): it is used to select the automatic stop of the spool carriage (upstroke phase)
depending on the height of the pallet being wrapped.
Icon (D2): it is used to select the programmed stop of the spool carriage (upstroke phase)
depending on the height of the pallet.
Enabling this button, (altimeter) will display another button next to button (E) to set the pallet
height.
To obtain a wrapping delay when this function is active, it is necessary to set a height greater
than that of the product to be wrapped.
E) Button: it is used to program the delay of the stopping point of the spool carriage during the
upstroke phase (only with automatic stop).
F) Button: it is used to enable and disable the programming of the distance from the ground
(offset) at the beginning of wrapping.
- Blue background: Function enabled.
- Grey background: Function disabled.
G) Buttons: they are used to program the positioning value and the number of reinforcing
wrappings.
The buttons are visible only if the function has been enabled with the button (F).
H) Button: it is used to enable and disable the reinforcing wrapping programming mode.
- Blue background: Function enabled.
- Grey background: Function disabled.
L) Buttons: they are used to program the positioning value and the number of reinforcing
wrappings.
The buttons are visible only if the function has been enabled with the button (H).
M) Button: it is used to enable and disable the cutting cycle programming mode (Optional).
N) Button: it is used to enable and disable the presser cycle programming mode (Optional).
O) Button: it is used to enable and disable the creasing head cycle programming mode
(Optional).
P) Button: it is used to access the page of special cycles (F1, F2,...).